My Arduino project essentially consists of an ESP32-CAM sending a photo to my Telegram group every 15min, then goes to sleep. When it wakes up, it evaluates the "brightess level" by reading the voltage from an LDR, if the brightness level is too low (night time), it goes back to sleep; otherwise it connects to the internet, takes a photo and sends it to me. I am aware the ADC pins of the ESP32 are distributed between ADC1 and ADC2 and that ADC2 should not be used when Wifi driver is in use. I a
ESP32-CAM PIR Motion Detector with Photo Capture
ESP32 - CAM OV2640. Module. WebServer - Internet of Things - MIT App Inventor Community
Seeeduino XIAO ESP32S3 Sense Board - A Tiny ESP32 Camera
ESP32/ESP8266 ADC with MicroPython - Measure Analog Readings
ESP32/ESP8266 ADC with MicroPython - Measure Analog Readings
HOW ESP32-CAM ADC, analogRead - Other Hardware Development - Arduino Forum
Help with using ESP32-CAM with SD Card, Ultrasonic sensor, & GPS MODULE - Project Guidance - Arduino Forum
How To Use ADS1115 16-Bit ADC with ESP32 – DIY Projects Lab
Using the ESP32-CAM MicroSD Card
Aideepen ESP32-CAM W-BT Board ESP32-CAM-MB Micro USB to Serial Port CH-340G with OV2640 2MP Camera Module Dual Mode Support NodeMCU : Everything Else
Using the ESP32-CAM MicroSD Card
ESP32-CAM AI-Thinker: Pinout, GPIO Pins, Features and How to Program
ESP32-cam + microphone - Project Guidance - Arduino Forum