I received the PETG Basic Lake Blue filament on 12 July and immediately installed it in my AMS then kicked off a print using all the default Bambu Studio settings. The print had tons of stringing. I then dried the filament at 65C, re-calibrated my P1P, and set the K factor for the filament only to have the print fail again. I even slowed down from 200mm/s outer wall to 60mm/s without success. I have had no issues printing the same part using esun brand PETG. Has anyone else had issues with the
Whats wrong with my printer? Petg filament Overture. : r/BambuLab
Can't get PETG to print clean : r/BambuLab
Bambu PETG profile not producing clean prints even with Bambu PETG Basic · Issue #2027 · bambulab/BambuStudio · GitHub
Troubleshooting bad PETG print - Bambu Lab X1 Series - Bambu Lab Community Forum
PETG Issues - Bambu Lab X1 Series - Bambu Lab Community Forum
Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum
Bamby Labs Petg Basic Fail - Troubleshooting - Bambu Lab Community Forum
Support Filament --> PETG for PLA and PLA for PETG and more - Bambu Filament and Accesories - Bambu Lab Community Forum
Sudden Failed PETG prints - Bambu Lab P1 Series - Bambu Lab Community Forum
PETG will not print in my X1 - Bambu Lab X1 Series - Bambu Lab Community Forum