HX711 Weight / Load Cell 2 Channel Pressure Sensor Amplifier Module – Envistia Mall

4.7

(100)

Écrire un avis

Plus

€ 1.00

Ajouter au panier

quantité

En Stock

Description

Thw HX711 Load Cell Amplifier is a low cost A/D converter module incorporating a very high precision 24 bit ADC and differential high gain inputs that allows you to easily read load cells, bridge sensors, pressure, strain and weight sensors to measure weight.

Our HX711 Load Cell Amplifier is a low-cost A/D converter module incorporating a very high precision 24 bit ADC and differential high gain inputs that allow you to easily read load cells, bridge sensors, pressure, strain and weight sensors to measure weight.

By connecting the amplifier to a microcontroller, you can read the changes in the resistance of the load cell and with some calibration, you’ll be able to get very accurate weight measurements. This can be used to create your own weight scale, process control, or simple presence detection.

Based on Avia Semiconductor’s patented technology, HX711 is a precision 24-bit analog-to-digital converter (ADC) designed for weight scales and industrial control applications to interface directly with a bridge sensor.

The input multiplexer selects either Channel A or B differential input to the low-noise programmable gain amplifier (PGA). Channel A can be programmed with a gain of 128 or 64, corresponding to a full-scale differential input voltage of ±20mV or ±40mV respectively, when a 5V supply is connected to VCC analog power supply pin. Channel B has a fixed gain of 32. An on-chip power supply regulator eliminates the need for an external supply regulator to provide analog power for the ADC and the sensor. There is no programming needed for the internal registers. All controls to the HX711 are through the pins.

The HX711 uses a two-wire interface (Clock and Data) for communication. Any microcontroller’s GPIO pins should work and numerous libraries have been written making it easy to read data from the HX711.

Load cells use a four-wire wheatstone bridge to connect to the HX711. These are commonly colored RED, BLK, WHT, GRN, and YLW. Each color corresponds to the conventional color coding of load cells:

Red (Excitation+ or VCC)
Black (Excitation- or GND)
White (Amplifier+)
Green (Amplifier -)
Yellow (Shield)

HX711 Features & Specifications:

Two selectable differential input channels
On-chip active low noise PGA with selectable gain of 32, 64 and 128
On-chip power supply regulator for load-cell and ADC analog power supply
On-chip oscillator requiring no external component with optional external crystal
On-chip power-on reset
Simple digital control and serial interface: pin-driven controls, no programming needed
Simultaneous 50 and 60Hz supply rejection
Current consumption including on-chip analog power supply regulator: normal operation < 1.5mA, power down < 1uA
Operation supply voltage range: 2.6V ~ 5.5V
Operation temperature range: -40 ~ +85oC
Dimensions: 34mm x 21mm x 3mm (1.34in x 0.8in x 0.12in) L x W x H